If they use painter’s tape to ‘protect’ the wallpaper, when they remove the tape, they will either take the inked layer along with it, or they will pull the paper itself completely away from the wall.Īgain I rant: Have ALL the other work done before the wallpaper goes up. It will also create a glossy surface that the wallpaper paste will not stick to. Once that barrier is in place, use a thin, angled handheld brush to repaint your baseboards, allowing that angled tip to slide between the tape and the wall, completely. This will make it impossible for me to sand the compound. Take a scraper or other thin straight edge, and push that 3mm tape edge down into the crevice between the carpet and the wall, creating a sort of lip or barrier between the two. Skim Coat How to Properly Skim Coat a Wall for Beginners Paint Drywall. They will also let their brush run beyond the molding, and onto my smoothing compound. paint on the walls while you are painting the baseboards. Thereverafter, there will be small but unsightly blobs and bumps embedded in the paint. I needed a white paint that would be soft and not too white, so I went with Benjamin Moore White Dove for the whole house. When I put up the paper and trim at the bottom I will need to wipe paste off the woodwork – and at that time, I will wipe off any residual smoothing compound.īut if the painters come and slap paint on now, I know they will not inspect the baseboards before they paint, and will put their paint right on top of the globs of smoothing compound. So some of my smoothing compound has slopped onto the baseboard. I have skim-floated the walls, and will sand them when I come to finish the job later. If the painters come to paint the baseboards, I already anticipate what will happen. This room is supposedly ‘ready for wallpaper.’ Yet the baseboards have not been painted.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |